BabaCAD

Discussion in english => General discussion about BabaCAD => Topic started by: jmoreyii on April 09, 2015, 03:04:12 pm

Title: New Guy Question
Post by: jmoreyii on April 09, 2015, 03:04:12 pm

I just loaded BabaCAD and when I open the program, I notice that there is an error message that MNULOAD command not recognized.
I'm assuming the menu didn't load.  Any thoughts from anyone....Help!

Title: Re: New Guy Question
Post by: babadmin on April 10, 2015, 09:18:11 am

MNULOAD command is reserved for LISP. Download and install LISP extension module (Homepage->Extension Modules section) and MNULOAD will load lisp routines and toolbars from bcad.mnu configuration file that can be found in .../ProgramFiles(x86)/BabaCAD/BabaCAD/Support. You can also add your .lsp files in ..Support/Lisp folder to be loaded on startup. After that you can type custom lisp commands in BabaCAD command line to execute (see examples in ..Support/Lisp folder).

Title: Re: New Guy Question
Post by: jmoreyii on April 10, 2015, 01:52:12 pm

Thank You!