BabaCAD

Discussion in english => General discussion about BabaCAD => Topic started by: HPW on April 24, 2016, 11:31:32 am

Title: Configure option to place custom toolbar
Post by: HPW on April 24, 2016, 11:31:32 am
Hello,

In the bcad.mnu file there is this Toolbar definition:

***TOOLBAR,LISP examples,lispexamples.bmp
43100,drawextent
43101,chcolor
43102,gear

Add an option to place the custom tollbar to a defined place.
Bordername or XPOS/YPOS or other

And an option to store all Positions in a INI-file after moving them by mouse.
And then restore on startup.

Regards

Hans-Peter
Title: Re: Configure option to place custom toolbar
Post by: babadmin on April 24, 2016, 01:39:27 pm
Good tip, thank you. Will add this in next release. I also think about saving toolbar position data in registry, but after your comment about running BabaCAD as portable, you are right, it's better to save this data to .ini file.

Thanks for good suggestions
Regards