Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ponytail

Pages: [1]
1
General discussion about BabaCAD / Re: Using SphereUnf.vlx
« on: February 21, 2016, 10:28:28 pm »
Thanks Babadmin,

I get it. Have to wait then....

Until then: is there an easy way to draw such unfolded obejcts?

2
General discussion about BabaCAD / Using SphereUnf.vlx
« on: February 20, 2016, 04:02:12 pm »
I am looking for a routine to make unfolded/flattened cones and spheres.
Tried SphereUnf.vlx in BabaCad: drag&drop don't work, but APPLOAD-command says it was installed.
But at the command Sphereunf it didn't work.
The above does work in a full Autocad-program, not in their LT-versions.

How can I get this thing to work or is there another routine to get my wanted result?

3
General discussion about BabaCAD / Re: Introducing
« on: September 05, 2014, 01:16:20 pm »
In addition: I made little recommandation for BabaCad in a big computermagazine in Netherlands; Computer-Idee.
So maybe there will be some more activitye here soon....

4
General discussion about BabaCAD / Introducing
« on: March 22, 2014, 01:26:59 pm »
Hello members,

I would like to give a very tiny introduction of myself.
I am a retired Dutchman from just over 60 years and shortly working with CAD.
Used AutoCad2008 LT and it got me hooked. Specially since I can also use a laserplotter to cut cardboard.

Autocad is heavy and expensive. Found out BabaCad looks very similar.
Gonna do some tests to see if the files made can also being used with the laser.
This appears not always being the case...

Greetings from Holland,
PT

Pages: [1]