BabaCAD
Discussion in english => General discussion about BabaCAD => Topic started by: HPW on April 25, 2016, 07:06:47 am
-
Hello,
Tested to open some DWG from ACAD 14 or 2000 format.
It fails to read the layout.
This is big fail in terms of DWG-compatibility.
If needed I can send testfile by mail.
Regards
Hans-Peter
-
There is layout reading bug in 1.3.5 beta version which is not fully tested. Download stable 1.3.4 version from main page.
-
I checked again, but it's not 1.3.5. beta bug. It is bug since 1.3 (earlier versions are good). I will fix this in next release. When saved from BabaCAD, and when you open dxf again in BabaCAD, layout is ok. Problem is with dwg and dxf saved in AutoCAD.