Discussion in english > General discussion about BabaCAD
No reading Layout of ACAD14+2000
(1/1)
HPW:
Hello,
Tested to open some DWG from ACAD 14 or 2000 format.
It fails to read the layout.
This is big fail in terms of DWG-compatibility.
If needed I can send testfile by mail.
Regards
Hans-Peter
babadmin:
There is layout reading bug in 1.3.5 beta version which is not fully tested. Download stable 1.3.4 version from main page.
babadmin:
I checked again, but it's not 1.3.5. beta bug. It is bug since 1.3 (earlier versions are good). I will fix this in next release. When saved from BabaCAD, and when you open dxf again in BabaCAD, layout is ok. Problem is with dwg and dxf saved in AutoCAD.
Navigation
[0] Message Index
Go to full version