Discussion in english > General discussion about BabaCAD

three points circle

(1/2) > >>

sigmaCad:
Hi,

I was using trial version for a while and there was circle command option to construct circle with three given points (i remember that I had just to type '3' in command line after circle command). I purchased home edition few months ago, but today when I tried to draw circle with three points, it just repeats "specify center point" after I type '3' in command line. Please help. I have licensed version of babacad home ed 3.0.5.

babadmin:
Just type '3P' instead of '3' (this is fixed after trial version). Licensed versions are updated with more features and fixes.

sigmaCad:
It works with 3p. Thx.

sigmaCad:
I used tangent/tangent circle construction command, and everything constructed correctly. But after that I tried to trim circle with tangents (to get arc part connected to tangent), it trimmed wrong part of circle. I have BabaCAD Home 2018 licensed version. Any workaround on this?

babadmin:
Trim command had a bug (in some situations, not always) on arc trim, but it's fixed now. Download and install patch for 2018 version (use download link in your license mail).

Navigation

[0] Message Index

[#] Next page