1
General discussion about BabaCAD / Re: Poly Line
« on: December 05, 2014, 03:06:34 am »
Well, then I eagerly await the next release!
Thank you.
Thank you.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General discussion about BabaCAD / Poly Line
« on: December 05, 2014, 02:32:30 am »
Hello,
I'm trying to edit a dwg file made in Acad 2004. It has a lot of plines of varying widths and donuts of various sizes. When I open the file, they all show up with a width of 1 instead of .035" or such. They just look like lines...
Any idea what i'm doing wrong?
Thank you!
PS, I also like full screen cursor lines.
I'm trying to edit a dwg file made in Acad 2004. It has a lot of plines of varying widths and donuts of various sizes. When I open the file, they all show up with a width of 1 instead of .035" or such. They just look like lines...
Any idea what i'm doing wrong?
Thank you!
PS, I also like full screen cursor lines.
Pages: [1]