Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sigmaCad

Pages: [1]
1
General discussion about BabaCAD / Upgrade to 2020?
« on: March 11, 2021, 07:27:08 pm »
I have licensed 2018 version. Is there an option to upgrade to 2020 or I have to pay the full price?

2
General discussion about BabaCAD / Re: three points circle
« on: November 27, 2019, 10:31:20 pm »
I used tangent/tangent circle construction command, and everything constructed correctly. But after that I tried to trim circle with tangents (to get arc part connected to tangent), it trimmed wrong part of circle. I have BabaCAD Home 2018 licensed version. Any workaround on this?

3
General discussion about BabaCAD / Drawing units
« on: May 03, 2019, 10:08:36 am »
I have drawing with inch units, but can't find units settings in babacad. Need help.

4
General discussion about BabaCAD / Re: three points circle
« on: December 17, 2018, 07:43:40 am »
It works with 3p. Thx.

5
General discussion about BabaCAD / three points circle
« on: December 16, 2018, 05:21:06 pm »
Hi,

I was using trial version for a while and there was circle command option to construct circle with three given points (i remember that I had just to type '3' in command line after circle command). I purchased home edition few months ago, but today when I tried to draw circle with three points, it just repeats "specify center point" after I type '3' in command line. Please help. I have licensed version of babacad home ed 3.0.5.

6
General discussion about BabaCAD / Can't open dwg drawing
« on: March 28, 2018, 11:50:40 pm »
I can't open dwg drawing. I got message 'unsupported version...'

Pages: [1]