1
General discussion about BabaCAD / Using SphereUnf.vlx
« on: February 20, 2016, 04:02:12 pm »
I am looking for a routine to make unfolded/flattened cones and spheres.
Tried SphereUnf.vlx in BabaCad: drag&drop don't work, but APPLOAD-command says it was installed.
But at the command Sphereunf it didn't work.
The above does work in a full Autocad-program, not in their LT-versions.
How can I get this thing to work or is there another routine to get my wanted result?
Tried SphereUnf.vlx in BabaCad: drag&drop don't work, but APPLOAD-command says it was installed.
But at the command Sphereunf it didn't work.
The above does work in a full Autocad-program, not in their LT-versions.
How can I get this thing to work or is there another routine to get my wanted result?