BabaCAD Forum

This forum is an archive: reading only, new posts and registrations are closed.

BabaCAD » General discussion about BabaCAD » Drawing units

Drawing units

sigmaCad

Drawing units

May 3, 2019, 08:08 UTC

I have drawing with inch units, but can't find units settings in babacad. Need help.

babadmin

Re: Drawing units

May 3, 2019, 13:00 UTC

Command "UNITS" (type in command line) to change between mm/feet/inch. Command exists in licensed versions (Home or Enterprise) only, not in trial version.

BabaCAD » General discussion about BabaCAD » Drawing units